User's Manual

142 Using the Storage Management Service
omreport Physical Disk Status
Table 6-13 describes the syntax for the omreport Physical Disk Commands
Table 6-13. omreport Physical Disk Commands
Required Command Levels (1, 2, 3)
and name=value pair
Optional name=value pairs Use
omreport storage pdisk controller=id
where id is the controller
number. For example:
controller=0
Displays all physical disks
attached to the specified
controller.
NOTE: If a physical disk was
replaced by another disk as
part of the replace member
operation, the state of the
physical disk is displayed as
Replacing.
connector=id
where id is the connector
number. For example:
connector=1
Displays all physical disks
attached to the specified
connector on the controller.
vdisk=id
where id is the virtual disk
number. For example:
vdisk=1
Displays all physical disks
included in the specified
virtual disk on the controller.
pdisk=connectorID :
targetID | connectorID :
enclosureID : slotID
where connectorID:targetID
is the connector number and
the physical disk number and
connectorID:enclosureID:slotI
D is the connector number,
enclosure number, and slot
number.
For example: pdisk=0:2 or
pdisk=0:1:2
Displays the specified
physical disk on the specified
connector on the controller.