User's Manual

162 Using the Storage Management Service
Example Syntax
To stop the patrol read task on controller 1, enter:
omconfig storage controller action=stoppatrolread
controller=1
NOTE: To be able to stop patrol read, the current patrol read mode should be set to
Manual.
omconfig Change Controller Properties
Use the following omconfig command to change any or all of the following
controller properties.
Complete Syntax
omconfig storage controller action=
setchangecontrollerproperties controller=<id>
abortcheckconsistencyonerror=<enabled/disabled>
allowreplacemember=<enabled/disabled> loadbalance=
<auto/disabled> autoreplacememberonpredictivefailure=
<enabled/disabled> bgirate=<rate> reconstructrate=
<rate> rebuildrate=<rate> checkconsistencyrate=<rate>
clearredundantpath=disabled
Example Syntax
To enable replace member operation, enter:
omconfig storage controller action=
setchangecontrollerproperties allowreplacemember=
enabled
omconfig Storage Virtual Disk
Use the following omconfig storage command syntax to replace a physical
disk that is part of a virtual disk with another physical disk.