Users Guide

74 Remote Access Controller
10 Click Apply Changes and then click OK to save the alert, paging, and user
configuration to the Server Administrator data repository.
Server Administrator returns to the
Users tab. The user you just created
and configured is displayed in the
User Name list.
Configuring an Existing DRAC User
NOTE: You must have Administrator privileges in Server Administrator to use the
Remote Access Controller.
To configure an existing DRAC user, perform the following steps:
1
Click Modular Enclosure → System/Server Module → Main System
Chassis/Main System
→ Remote Access and then click the Users tab.
The
Remote Access Users window appears.
2 Click the user name for the user you want to configure.
3 Change the password:
a Select the check box next to Change Password and type a new
password in the
Password field.
b Type the new password again in the Confirm Password field.
4 Configure numeric paging (for DRAC III users only):
a Select the check box next to Enable Numeric Paging and enter a
pager number in the
Pager Number field.
b Enter the numeric message in the Numeric Message field that you
want the DRAC to send when it receives certain events.
5 Configure e-mail paging:
a Select the check box next to Enable Email Paging and enter an e-mail
address in the
Email Address field.
b Enter the message in the Message field that you want the DRAC to
send when it receives certain events.
book.book Page 74 Monday, July 7, 2008 2:59 PM