User's Manual

228 Using the Storage Management Service
where id is the controller ID and battery ID as reported by the omreport
command. To obtain this value, enter omreport storage controller to display
the controller IDs and then enter omreport storage battery controller=ID to
display the ID for the controller battery.
Example Syntax
To delay the learn cycle for three days and 12 hours on controller 1, enter:
omconfig storage battery action=delaylearn
controller=1 battery=0
days=3 hours=12
omconfig Connector Commands
The following sections provide the omconfig command syntax required to
execute connector tasks.
omconfig Rescan Connector
Use the following omconfig command to rescan a controller connector. This
command rescans all connectors on the controller and is therefore similar to
performing a controller rescan.
NOTE: This command is not supported on SAS controllers.
Complete Syntax
omconfig storage connector action=rescan
controller=id connector=id
where id is the controller ID and the connector ID as reported by the
omreport command. To obtain these values, enter omreport storage
controller to display the controller IDs and then enter omreport storage
connector controller=ID to display the IDs for the connectors attached to
the controller.
Table 6-25. omconfig Connector Commands
Required Command Levels (1, 2, 3) Optional name=value pairs
omconfig storage connector
action=rescan controller=id connector=id