User's Manual

176 Using the Storage Management Service
omreport Enclosure Status
Table 6-8 describes the syntax for the omreport Enclosure Commands.
Table 6-7. omreport Connector Commands
Required Command
Levels (1, 2, 3)
Optional name=value pairs Use
omreport storage
connector
Displays all connectors present on
all controllers on the system.
NOTE: This command works only
when the controller ID is specified.
controller=id
where id is the controller
number. For example:
controller=0
Displays the connector on the
specified controller.
controller=id
where id is the controller
number. For example:
controller=0
connector=id
where id is the connector
number. For example:
connector=0
Displays information for the
specified connector on the
controller.
NOTE: When the connectors are
connected to the enclosure in
redundant path mode, the Name of
the connector is displayed as
Logical Connector.
Table 6-8. omreport Enclosure Commands
Required Command Levels
(1, 2, 3)
Optional name=value pairs Use
omreport storage
enclosure
Displays property information
for all enclosures attached to the
system.