Users Guide

38 Setup and Administration
rwcommunity public 127.0.0.1
3
To enable SNMP configuration changes, restart the SNMP agent by
typing:
/etc/init.d/snmpd restart
Configuring Your System to Send Traps to a Management Station
Server Administrator generates SNMP traps in response to changes in the
status of sensors and other monitored parameters. One or more trap
destinations must be configured on the system running Server Administrator
for SNMP traps to be sent to a management station.
To configure your system running Server Administrator to send traps to a
management station, edit the SNMP agent configuration file,
/etc/snmp/snmpd.conf, and perform the following steps:
1
Add the following line to the file:
trapsink IP_address community_name
where IP_address is the IP address of the management station and
community_name is the SNMP community name.
2 To enable SNMP configuration changes, restart the SNMP agent by typing:
/etc/init.d/snmpd restart
Configuring the SNMP Agent on Systems Running Supported VMware
ESX 4.X Operating Systems to Proxy VMware MIBs
The ESX 4.X server can be managed through a single default port 162 using
the SNMP protocol. To do this, snmpd is configured to use the default port
162 and vmwarehostd is configured to use a different (unused) port, for
example, 167. Any SNMP request on the VMWare MIB branch is rerouted to
the
vmware-hostd using the proxy feature of the snmpd daemon.
The VMWare SNMP configuration file can be modified manually on the ESX
server or by running VMWare Remote Command-Line Interface (RCLI)
command
vicfg-snmp from a remote system (Windows or Linux). The RCLI
tools can be downloaded from the VMware website at
vmware.com/download/vi/drivers_tools.html.
To configure the SNMP agent:
book.book Page 38 Tuesday, March 6, 2012 6:13 PM