Command Line Interface Guide

omconfig: Managing Components Using the Instrumentation Service 109
attribute=
serialport1
setting=off | auto |
com1 | com3 |
bmcserial | bmcnic |
rac | com1bmc
off: Disables serial port 1.
auto: Maps serial port 1 to a COM port.
com1: Maps serial port 1 to COM port 1.
com3: Maps serial port 1 to COM port 3.
bmcserial: Maps serial port 1 to
BMC Serial.
bmcnic: Maps serial port 1 to the
Baseboard Management Controller
(BMC) NIC.
rac: Maps serial port 1 to the Remote
Access Controller (RAC.)
com1bmc: Maps serial port 1 to COM
port 1 bmc.
NOTE: This command is applicable to
selected x8xx systems.
attribute=
serialport2
setting=off | auto |
com2 | com4
off: Disables serial port 2.
auto: Maps serial port 2 to a COM port.
com2: Maps serial port 2 to COM port 2.
com4: Maps serial port 2 to COM port 4.
attribute=speaker setting=on | off on: Enables the speaker.
off: Disables the speaker.
attribute=
cputurbomode
setting=enabled |
disabled
CPU turbo mode can increase the CPU
frequency when the system is operating
below the thermal, power, or current
limits.
enabled: Enables CPU Turbo Mode.
disabled: Disables CPU Turbo Mode.
Table 4-3. BIOS Setup Settings on systems prior to PowerEdge
yx2x systems
name=value pair 1
attribute=
name=value pair 2
setting=
Description