Command Line Interface Guide

110 omconfig: Managing Components Using the Instrumentation Service
attribute=uausb setting=on | backonly
| off
on: Enables the user-accessible
USB port(s.)
backonly: Enables only the user
accessible USB port(s) located at the
back of the system.
off: Disables the user-accessible
USB port(s.)
attribute=usb setting=enabled |
disabled
enabled: Enables the USB port(s.)
disabled: Disables the USB port(s.)
NOTE: Depending on the system's
hardware you can configure either usb or
usbb.
attribute=usbb setting=enabled |
enabledwithbios|
disabled
enabled: Enables the USB port(s) during
system boot, without BIOS support.
enabledwithbios: Enables the USB
port(s) during the system boot, with
BIOS support.
disabled: Disables the USB port(s)
during system boot.
NOTE: Depending on the system's
hardware you can configure either usb or
usbb.
attribute=cstates setting=enabled |
disabled
enabled: Enables the processor to go
into a deep sleep state when the system
is not utilized.
disabled: Disables the processor to go
into a deep sleep state when the system
is not utilized.
Table 4-3. BIOS Setup Settings on systems prior to PowerEdge
yx2x systems
name=value pair 1
attribute=
name=value pair 2
setting=
Description