Command Line Interface Guide

omconfig: Managing Components Using the Instrumentation Service 127
omconfig chassis pwrmanagement or omconfig mainsystem
pwrmanagement
Use the omconfig chassis pwrmanagement or omconfig mainsystem
pwrmanagement command to configure power cap and manage profiles that
control power utilization.
NOTE: This command is valid only on systems prior to PowerEdge yx2x systems.
opmode=mirror |
optimizer | advecc
mirror: Switches the systems to a mirrored copy of the memory if
the failing module has an uncorrectable memory event. In the
mirror mode, the operating system does not switch back to the
original module until the system reboots.
optimizer: Enables the DRAM controllers to operate
independently in 64-bit mode and provide optimized memory
performance.
advanced ECC (advecc): Enables the two DRAM controllers to
combine in 128-bit mode and provide optimized reliability.
Memory that are not teamed by the controllers is not reported to
the operating system.
Table 4-10. omconfig chassis pwrmanagement or omconfig mainsystem
pwrmanagement
name=value pair 1 name=value pair 2 Description
config=budget cap=<value> Sets the threshold value for power
budget.
NOTE: From PowerEdge yx2x system
onwards, power budget requires
license to configure power cap. If the
appropriate license is not installed or
has expired, the system displays an
error message. For more information,
see The Dell Licensing Management
Guide on support.dell.com.
setting=enable |
disable
enable: Enables powercap settings.
disable: Disables powercap settings.
Table 4-9. omconfig chassis memorymode or omconfig mainsystem memorymode
name=value pair 1 Description