Command Line Interface Guide

184 omconfig system or servermodule assetinfo: Editing Cost of Ownership Values
Example Command for Adding Service Information
To provide a value for a service parameter, type a command of the form:
omconfig system assetinfo info=service
<name=value pair 2> or
omconfig system assetinfo info=service
<name=value pair 2>.
For example, type:
omconfig system assetinfo info=service vendor=
fixsystemco
or
omconfig servermodule assetinfo info=service
vendor=fixsystemco
The following message is displayed:
Asset information set successfully.
You can type more than one omconfig system assetinfo or omconfig
servermodule assetinfo command at the same time, as long as all the
parameters for name=value pair 2 belong to the same name=value pair 1.
For an example, see "Example Commands for Adding Acquisition
Information" on page 173.
Adding Support Information
Support refers to technical assistance that the system user can seek when the
user seeks guidance on the proper use of a system to perform tasks. Table 5-10
shows the valid parameters for adding support information.
Table 5-10. omconfig system assetinfo info=support or omconfig servermodule
assetinfo info=support
Command
Level 1
Command
Level 2
Command
Level 3
Name=
Value Pair 1
Name= Value Pair 2 Description
omconfig
system or
servermodul
e
assetinfo
info=
support