Command Line Interface Guide

Using the Storage Management Service 193
Table 6-2. Syntax For Name=Value Pairs For Parameters
Syntax Description
controller=id Indicates the controller ID as reported by the omreport storage
controller command. To obtain these values, type omreport
storage controller to display the controller IDs and
then type omreport storage pdisk controller=id
to display the IDs for the physical disks attached to the
controller.
For example, the controller=id parameter is specified as
controller=1.
connector=id Indicates the connector ID as reported by the omreport
command. To obtain this value, type omreport storage
controller to display the controller IDs and then type
omreport storage connector controller=id to
display the IDs for the connectors attached to the controller.
For example, the connector=id parameter is specified as
connector=2.
vdisk=id Indicates the virtual disk ID as reported by the omreport
command. To obtain this value, type omreport storage
controller to display the controller IDs and then type
omreport storage vdisk controller=id to display
the IDs for the virtual disks on the controller.
For example, the vdisk=id parameter is specified as vdisk=3.
enclosure=
<ENCLOSUREID>
Indicates a particular enclosure by specifying either enclosure=
connector or enclosure=connector:enclosureID.
To obtain these values, type omreport storage
controller to display the controller IDs and then type
omreport storage enclosure controller=id to
display the IDs for the enclosures attached to the controller.
pdisk=<PDISKID> Indicates a particular physical disk by specifying either
connector:targetID or connector:enclosureID:targetID.
To obtain the values for the connector, enclosure, and physical
disk (targetID), type omreport storage controller to
display the controller IDs and then type omreport storage
pdisk controller=id to display the IDs for the physical
disks attached to the controller.