Command Line Interface Guide

omconfig storage Commands 215
where id is the controller ID and virtual disk ID as reported by the omreport
command. To obtain these values, type omreport storage controller to display
the controller IDs and then type omreport storage vdisk controller=ID to
display the IDs for the virtual disks attached to the controller.
Example Syntax
To initialize physical disk 4 on controller 1, type:
omconfig storage pdisk action=initialize
controller=1 pdisk=4
omconfig Offline Physical Disk
Use the following omconfig command syntax to offline a physical disk:
Complete Syntax
omconfig storage pdisk action=offline controller=
id pdisk=<PDISKID>
where id is the controller ID. The <PDISK> variable specifies the physical
disk.
To obtain these values, type omreport storage controller to display the
controller IDs and then type omreport storage pdisk controller=ID to
display the IDs for the physical disks attached to the controller.
Example Syntax
In this example, you want to offline physical disk 3 on connector 0 of
controller 1. On a SAS controller, the physical disk resides in enclosure 2.
Example for SCSI, SATA, and ATA Controllers
To offline the physical disk described in this example, type:
omconfig storage pdisk action=offline controller=1
pdisk=0:3
Example for SAS Controllers
To offline the physical disk described in this example, type:
omconfig storage pdisk action=offline controller=1
pdisk=0:2:3