Command Line Interface Guide

220 omconfig storage Commands
Complete Syntax
omconfig storage pdisk action=clear controller=id
pdisk=<PDISKID>
where id is the controller ID. The <PDISK> variable specifies the physical
disk.
To obtain these values, type omreport storage controller to display the
controller IDs and then type omreport storage pdisk controller=ID to
display the IDs for the physical disks attached to the controller.
Example Syntax
In this example, you want to clear physical disk 3 on connector 0 of controller 1.
On a SAS controller, the physical disk resides in enclosure 2.
Example for SAS Controllers
To clear the physical disk described in this example, type:
omconfig storage pdisk action=clear controller=1
pdisk=0:2:3
omconfig Cancel Clear Physical Disk
Use the following omconfig command to cancel a clear operation in progress
on a physical disk.
Complete Syntax
omconfig storage pdisk action=cancelclear
controller=id pdisk=<PDISKID>
where id is the controller ID. The <PDISK> variable specifies the physical
disk.
To obtain these values, type omreport storage controller to display the
controller IDs and then type omreport storage pdisk controller=ID to
display the IDs for the physical disks attached to the controller.
Example Syntax
In this example, you want to cancel the clear of physical disk 3 on connector 0
of controller 1. On a SAS controller, the physical disk resides in enclosure 2.