Command Line Interface Guide

omconfig: Managing Components Using the Instrumentation Service 97
Table 4-3 shows the name=value pairs you can use with this command on
systems prior to PowerEdge yx2x systems.
Table 4-3. BIOS Setup Settings on systems prior to PowerEdge yx2x systems
name=value pair 1
attribute=
name=value pair 2
setting=
Description
attribute=
acpwrrecovery
setting=off | last| on off: System is turned off.
last: System returns to previous state.
on: System is turned on.
delay=random |
immediate | timedelay
time <value>
random: System is turned on with
random delay.
immediate: System returns to previous
state immediately.
timedelay <value>: System is turned
on based on user specified time delay.
attribute=bezel setting=enabled |
disabled
enabled: Enables the bezel removal
intrusion check during system boot.
disabled: Disables the bezel removal
intrusion check during system boot.
attribute=
bootsequence
setting=diskettefirst |
hdonly | devicelist
|cdromfirst |
opticaldrive
Instructs the BIOS which device is used
to boot the system, and the order in
which the boot routine is to check each
device.
NOTE: On Linux systems, user or user
groups upgraded to administrator or
administrator groups cannot configure
this BIOS setup setting.
attribute=
bootmode
setting=uefi | bios uefi: Enables the system to boot to
operating systems that support Unified
Extensible Firmware Interface (UEFI.)
bios: Enables the system to boot to
operating systems that do not support
UEFI.