Command Line Interface Guide

98 omconfig: Managing Components Using the Instrumentation Service
attribute=
bootorder
sequence=aliasname1,
aliasname2,.....
aliasnameN
Configures the boot sequence according
to the set aliasnames. To view the set
alias names, run the command
omreport chassis
biossetup attribute=
bootorder
.
NOTE: On Linux systems, user or user
groups upgraded to administrator or
administrator groups cannot configure
this BIOS setup setting.
attribute=
hddorder
sequence=aliasname1,
aliasname2,.....
aliasnameN
Configures the BIOS setup hard disk
sequence according to the set
aliasnames. Changes takes effect after
rebooting the system. To view the set
alias names, run the command
omreport chassis
biossetup attribute=
bootorder
.
NOTE: On Linux systems, user or user
groups upgraded to administrator or
administrator groups cannot configure
this BIOS setup setting.
attribute=cstates setting=enabled |
disabled
enabled: Enables the processor to go into a
deep sleep state when the system is not
utilized.
disabled: Disables the processor to go
into a deep sleep state when the system
is not utilized.
Table 4-3. BIOS Setup Settings on systems prior to PowerEdge
yx2x systems
name=value pair 1
attribute=
name=value pair 2
setting=
Description