Installation manual

Preinstallation Setup 35
Configuring the Windows Firewall for WinRM
To configure the Windows Firewall for WinRM:
1
Open the Control Panel .
2 Click Windows Firewall .
3 Click the Exceptions tab.
4 Select the Windows Remote Management check box. If you do not
see the check box, click
Add Program to add Windows Remote
Management.
Configuring the Envelope Size for WinRM
To configure the envelope size for WinRM:
1
Open a command prompt.
2 Ty p e winrm g winrm/config .
3 Check the value of the MaxEnvelopeSizekb attribute. If the value is
less than
4608 , type the following command:
winrm s winrm/config @{MaxEnvelopeSizekb="4608"}
4
Set the value of MaxTimeoutms to 3 minutes:
winrm s winrm/config @{MaxTimeoutms ="180000"}
On WinRM version 2.0, enable the compatibility mode for WinRM version
2.0 to use port 443. WinRM version 2.0 uses port 5986 by default. To enable
the compatibility mode, type the following command:
winrm s winrm/config/Service
@{EnableCompatibilityHttpsListener="true"}