Installation manual
40 Preinstallation Setup
On Red Hat Enterprise Linux 6, for the sblim-sfcb and openwsman to
start automatically after a reboot you need to change the run-levels using the
chkconfig utility. For example, if you want to run sblim-sfcb in run-
levels 3 and 5, use the following command:
#chkconfig sblim-sfcb on --level 35
NOTE: For more information on chkconfig and its usage, see the operating
system documentation.
The managed system is configured and is ready to be used by the Server
Administrator Web Server.
Winbind Configuration for openwsman and sfcb
for Red Hat Enterprise Linux Operating Systems
Follow the instructions mentioned below to configure openwsman and sfcb
on 32-bit OMI installation. In case of a 64-bit installation, replace lib with
lib64.
1
Back up the following files:
•
/etc/pam.d/openwsman
•
/etc/pam.d/sfcb
•
/etc/pam.d/system-auth
2
Replace the content of
/etc/pam.d/openwsman
and
/etc/pam.d/sfcb
with:
auth required pam_stack.so service=system-auth
auth required /lib/security/pam_nologin.so
account required pam_stack.so service=system-auth
3
Replace the content of
/etc/pam.d/system-auth
with:
%PAM-1.0
This file is auto-generated.
User changes will be destroyed the next time
authconfig is run.
auth required /lib/security/$ISA/pam_env.so