SNMP Reference Guide

Traps 711
Memory Device Traps
Memory device messages provide status and warning information for memory
modules present in a particular system. Memory devices determine health
status by counting the number of ECC memory corrections.
NOTE: A value of failure or non-recoverable does not indicate a system
failure or loss of data, but rather that the specified system exceeded the specified
ECC correction threshold. Although the system continues to function, you should
perform system maintenance as described in Table 27-10.
Power Supply Failure
1354 Power supply detected a failure
Sensor location: <Location in
chassis>
Chassis location: <Name of
chassis>
Previous state was: <State>
Power Supply type:
<type of
power supply>
<Additional power supply status
information>
If in configuration error state:
Configuration error type: <type
of configuration error>
Error A power supply has been
disconnected or has failed.
The sensor location, chassis
location, previous state, and
additional information
about the power supply
event are provided.
Table 27-10. Memory Device Messages
TrapID Description Severity Cause
1403 Memory device status: <status>
Memory device location:
<Location in chassis>
Possible memory module event
cause: <list of causes>
Warning A memory device correction
rate exceeded an acceptable
value. The memory device
status and location are
provided.
Table 27-9. Power Supply Traps
(continued)
TrapID Description Severity Cause
book.book Page 711 Tuesday, February 28, 2012 2:19 PM