SNMP Reference Guide

Storage Management Alert Reference 735
The alert severity levels are as follows:
SNMP Support for Storage Management Alerts
By default, Storage Management installs SNMP trap forwarding support.
For this support to function, you should have SNMP installed on the
managed system prior to installing Storage Management.
NOTE: For more information on installation requirements and SNMP, see the
Server Administrator documentation.
SNMP Trap Forwarding
The Storage Management alerts are displayed in the Server Administrator
alert log and are forwarded to the Windows application alert log. If you have
SNMP installed on the managed system (and the SNMPservice is running),
the Storage Management alerts in the Windows application alert log are
forwarded as SNMP traps. In order for these traps to be viewable, however,
a target system or application must be configured to receive these traps.
SNMP traps that are generated by Storage Management can be viewed in any
standard SNMP-compatible enterprise management console.
Table 28-1. Storage Management Alert Severity
Alert Severity Component Status
OK/Normal/Informational No action is required. The alert is provided for
informational purposes and does not indicate an error
condition. For example, the alert may indicate the
normal start or stop of an operation.
Warning/Non-critical A component requires attention. This alert indicates a
potential problem, but does not necessarily mean that
the system has currently lost data or is nonfunctional.
For example, a Warning/Non-critical alert may indicate
that a component (such as a temperature probe in an
enclosure) has crossed a warning threshold.
Critical/Failure/Error A component has either failed or failure is imminent.
This alert indicates a serious problem such as data loss or
a loss of function. For example, a Critical/Failure/Error
alert may indicate that an array disk has failed.
book.book Page 735 Tuesday, February 28, 2012 2:19 PM