Reference Guide

Command Level
1
Command Level
2
Command Level
3
Use
fluidcachepool Displays fluid cache pool properties.
partition Displays the partition details of the specified virtual disk.
fluidcachedisk Displays the fluid cache disk properties.
Omreport Physical Disk Status
The following table describes the syntax for the omreport Physical Disk commands.
Table 67. Omreport Physical Disk Commands
Required Command Levels (1, 2, 3)
And name=value pair
Optional name=value pairs Use
omreport storage pdisk controller=id, where id is the
controller number. For example,
controller=0
Displays all physical disks attached to
the specified controller.
NOTE: If a physical disk was
replaced by another disk as part
of the replace member
operation, the state of the
physical disk is displayed as
Replacing.
vdisk=id, where id is the virtual disk
number. For example, vdisk=1
Displays all physical disks included in
the specified virtual disk on the
controller.
cachecade=id where id is the
cachecade number. For example,
cachecade=1
Displays all physical disks included in
the specified cachecade on the
controller.
connector=id where id is the
connector number. For example,
connector=1
Displays all physical disks attached to
the specified connector on the
controller.
pdisk=connectorID : targetID |
connectorID : enclosureID : slotID,
where connectorID:targetID is the
connector number and the physical
disk number and
connectorID:enclosureID:slotID is the
connector number, enclosure number,
and slot number. For example,
pdisk=0:2 or pdisk=0:1:2
Displays the specified physical disk
on the specified connector on the
controller.
omreport Virtual Disk Status
The following table describes the syntax for the omreport Virtual Disk commands:
124