Reference Guide

Required Command Levels (1, 2, 3)
and name=value pair
Optional name=value pairs Use
NOTE: For SCSI controllers, the
ID specified in
enclosure=<ENCLOSUREID> is
the connector number and for
Serial Attached SCSI (SAS)
controllers, ID is the
connectorNumber:EnclosureInde
x.
controller=id
enclosure=<ENCLOSUREID> info=fans
index=n where id is the controller
number and ENCLOSUREID is the
enclosure number and n is the number
of a fan. For example: controller=0
enclosure=2 info=fans index=1
Displays the specified fan.
Omreport Power Supply Status
The following table describes the syntax for the omreport Power Supply commands
Table 73. Omreport Power Supply Commands
Required Command Levels (1, 2, 3) and
name=value pair
Optional name=value pairs Use
omreport storage enclosure Displays property information for all
enclosures attached to the system.
controller=id
enclosure=<ENCLOSUREID>
info=pwrsupplies where id is the
controller number and ENCLOSUREID
is the enclosure number. For example:
controller=0 enclosure=2
Displays the power supplies for the
specified enclosure.
controller=id
enclosure=<ENCLOSUREID>
info=pwrsupplies index=n where id is
the controller number and
ENCLOSUREID is the enclosure
number and n is the number of a
power supply. For example:
controller=0 enclosure=2
info=pwrsupplies index=1
Displays the specified power supply.
Omreport EMM Status
The following table describes the syntax for the omreport EMM commands
NOTE: The status of the EMMs is displayed as degraded if there is a mismatch between the EMM firmware.
127