Manualshelf

Reference Guide

ManualsBrandsDell ManualsRAID controllersOpenManage Server Administrator Version 7.3
21222324252627282930
Parameter Description
Console Redirection After Boot Displays whether console redirection after system reboot is enabled or disabled.
External Serial Connector Displays whether the external serial connector is mapped to Serial Device 1, Serial
Device 2, or a Remote Access Device.
Console Redirection Failsafe
Baud Rate
Displays the setting for console redirection failsafe baud rate.
Serial Address Select Displays port address for the serial devices.
BIOS Setup Groups On PowerEdge yx2x Systems
The following table lists the available groups of the BIOS setup parameters on PowerEdge
yx2x
systems.
NOTE: Based on the hardware configuration, the attributes may vary in a specific group.
Table 6. BIOS Setup Groups On PowerEdge yx2x Systems
Group Description
BIOS Boot Settings Controls the system boot settings when bootmode is set to bios.
Boot Settings Controls the system boot settings when bootmode is set to bios.
Embedded Server Management Sets up the Embedded Server Management options.
Integrated Devices Controls the devices integrated on the system board.
Memory Settings Controls the system memory settings.
Miscellaneous Settings Controls some miscellaneous system settings.
One-Time Boot Supports one-time boot to a specified device.
Processor Settings Controls the processor(s) settings of the system.
SATA Settings Control the embedded SATA ports settings.
Serial Communication Controls the Serial Communication options.
Slot Disablement Controls the system slots that are present on the system.
System Information Displays the information that uniquely identifies the system.
System Profile Settings Controls the power management settings.
System Security Controls the security features of the system.
UEFI Boot Settings Controls the system boot settings when boot mode is set to uefi.
Omreport Chassis Currents Or Omreport Mainsystem Currents
This command is no longer available through Server Administrator.
Omreport Chassis Fans Or Omreport Mainsystem Fans
Use the omreport chassis fans or omreport mainsystem fans command to view the fan probe status and settings. Type:
omreport chassis fans index=n
27