Command Line Interface Guide

Event Name Description
event=redunlost Sets action or enables or disables alert generation when the system
fans and/or power supplies become inoperative, resulting in a lost or a
no redundant components working condition for that component.
event=systempowerwarn Sets actions when a power consumption probe detects a warning
value.
event=systempowerfail Sets actions when a power consumption probe detects a failure value.
event=tempwarn Sets action or enables or disables alert generation when a temperature
probe detects that the temperature is approaching the maximum high
or low limits.
event=removableflashmediapre
sent
Sets actions that Server Administrator performs when the system
detects a removable flash media.
event=removableflashmediawa
rn
Sets actions that Server Administrator performs when a removable
flash media warning is displayed.
event=removableflashmediafail Sets actions that Server Administrator performs when a removable
flash media fails.
event=tempfail Sets action or enables or disables alert generation when a temperature
probe detects that the temperature is either too high or low for proper
operation.
event=voltfail Sets action or enables or disables alert generation when a voltage
probe detects that the voltage is too low for proper operation.
event=intdualsdcardcritical Sets actions that Server Administrator performs when an internal dual
SD card critical event occurs.
event=intdualsdcardwarn Sets actions that Server Administrator performs when an internal dual
SD card warning is displayed.
event=intdualsdcardabsent Sets actions that Server Administrator performs when an internal dual
SD card is not available.
event=intdualsdcardredunlost Sets actions that Server Administrator performs when the redundancy
of an internal dual SD card is lost.
event=watchdogasr Enables or disables alert generation configured by the ASR when the
system has hung or is not responding.
Omconfig System Events Or Omconfig Servermodule Events
Use the omconfig system events or omconfig servermodule events command to enable and disable
SNMP traps for the components on your system.
NOTE: Not all event types are present on the system.
There are four parameters in the name=value pair component of the omconfig system events command:
• Source
• Type
• Severity
110