Command Line Interface Guide

Example Command For Adding Depreciation Information
To provide a value for a depreciation parameter, type a command of the form: omconfig system
assetinfo info=depreciation <name=value pair 2> or omconfig servermodule assetinfo info=depreciation
<name=value pair 2>. For example, type:
omconfig system assetinfo info=depreciation method=straightline
or
omconfig servermodule assetinfo info=depreciation method=straightline
The following message is displayed:
Asset information set successfully.
You can type more than one omconfig system assetinfo or omconfig servermodule assetinfo command
at the same time, as long as all the parameters for name=value pair 2 belong to the same name=value
pair 1. For an example, see Example Commands For Adding Acquisition Information.
Adding Extended Warranty Information
Use the omconfig system extwarranty or omconfig servermodule extwarranty command to assign values
for extended warranty information. A warranty is a contract between the manufacturer or dealer and the
purchaser of a system. The warranty identifies the components that are covered for repair or replacement
for a specified length of time or usage. The extended warranty comes into force after the original
warranty expires. For details on how to edit warranty values, see Adding Warranty Information.
The following table displays the valid parameters for the command
Table 53. Valid Parameters Of omconfig system assetinfo info=extwarranty Or omconfig servermodule
assetinfo info=extwarranty
Command
Level 1
Command
Level 2
Command
Level 3
Name= Value
Pair 1
Name= Value Pair 2 Description
omconfig system or
servermodule
assetinfo info=extwarran
ty
cost=<cost> Cost of the
extended warranty
service.
enddate=<enddate> Date the extended
warranty agreement
ends.
provider=<provider
>
Business entity that
provides the
extended warranty
service.
startdate=<startdate
>
Date the extended
warranty service
begins.
120