Command Line Interface Guide

Table 66. omreport Virtual Disk Commands
Required Command Levels (1, 2,
3)
Optional name=value pairs Use
omreport storage vdisk Displays property information for
all virtual disks on all controllers.
controller=id, where id is the
controller number. For example,
controller=0.
Displays all virtual disks on the
specified controller.
controller=id vdisk=id, where id
is the controller number and the
virtual disk number. For example,
controller=0 vdisk=1.
Displays the specified virtual disk
on the controller.
Omreport Controller Status
The following table describes the syntax for the omreport Controller commands
Table 67. Omreport Controller Commands
Required Command
Levels (1, 2, 3)
Optional name=value pairs Use
omreport storage
controller
Displays property information for all controllers
attached to the system.
controller=id, where id is
the controller number. For
example, controller=0
Displays the specified controller and all attached
components such as enclosures, virtual disks,
physical disks, and so on.
controller=id
info=foreignkeyids
Displays the locked foreign configuration
information for import or clear operations.
controller=id
info=pdslotreport
Displays the empty and occupied slot details of
enclosures in the controller.
NOTE: This command is not supported on
Blackplane, SCSI, and SWRAID controllers.
Omreport Enclosure Status
The following sections provide the omreport storage enclosure command syntax required to execute the
enclosure commands. The following table describes the syntax for the omreport Enclosure commands.
Table 68. Omreport Enclosure Commands
Required Command
Levels (1, 2, 3)
Optional name=value pairs Use
omreport storage
enclosure
Displays property information for all
enclosures attached to the system.
controller=id, where id is the controller
number
Displays all enclosures connected to
the controller.
controller=id
enclosure=<ENCLOSUREID>, where id
Displays the specified enclosure and its
components.
135