Command Line Interface Guide

name=value pair 1 attribute= name=value pair 2 setting= Description
• nic1isci: Enables iSCSI on the
first NIC and none (no PXE or
iSCSI) on the second NIC.
• nic2isci: Enables none (no
PXE or iSCSI) on the first NIC
and iSCSI on the second NIC.
• nic1pxenic2isci: Enables PXE
on the first NIC and iSCSI on
second NIC.
• nic1iscinic2pxe: Enables iSCSI
on the first NIC and PXE on
second NIC.
The following options are
deprecated:
• onpxeboth: Enables PXE on
both the NICs.
• onpxenone: PXE is not
enabled on either of the NICs.
• onpxenic1: Enables PXE on
NIC 1.
• onpxenic2: Enables PXE on
NIC 2.
attribute=embhypvisor setting=enabled | disabled
• enabled: Enables the
embedded hypervisor.
• disabled: Disables the
embedded hypervisor.
attribute=embvideoctrl setting=enabled | disabled
• enabled: Enables the
embedded video controller as
the primary video device.
• disabled: Disables the
embedded video controller as
the primary video device.
attribute=esataport setting=off | auto
• off: Sets the embedded SATA
port value to off.
• auto: Sets the embedded
SATA port value to auto.
attribute=extserial setting=com1 | com2 | rad
• com1: Maps the external serial
connector to COM 1.
• com2: Maps the external
serial connector to COM 2.
• rad: Maps the external serial
connector to the remote
access device.
attribute=fbr setting=9600 | 19200 | 57600 |
115200
• 9600: Sets the console
redirection failsafe baud rate
to 9600 bits per second.
70