Release Notes

The following is an example of the effect of this behavior:
o On certain systems, the first time that the thresholds for a probe are changed
after Server Administrator is installed; the current threshold values for that
probe are saved as the default threshold values by writing the values to a
configuration file. When "Set to Default" is performed after the first change of
the thresholds, Server Administrator sets the threshold values to the values
that were saved in the configuration file as the default. If the system running
the VMware ESXi operating system is reset without a graceful shutdown
before the changes to the configuration file are updated to the disk, the user-
defined thresholds become the default thresholds.
• DF315853: Some Server Administrator CLI commands functions properly only when run
from the elevated console window. It is recommended that you use the elevated
console
for running the CLI.
• Due to some limitations, you cannot log on simultaneously to multiple browser
instances/tabs using SSO login, as only one session remains active while the other
sessions expire.
• DF489034: Intel TXT configuration fails due to Virtualization technology dependency
• If the current Virtualization Technology attribute setting is "Disabled" (Virtualization
Technology is part of the Processor Settings group on the BIOS setup page); the Intel TXT
attribute configuration fails on the Server Administrator user interface (System -> Main
System Chassis -> BIOS -> Setup ->System Security.) To resolve this issue, configure
Virtualization technology setting to "Enabled" and reconfigure the Intel TXT attribute, if it
is
configurable.
• DF549057: When an operating system is installed through USC, the BIOS attributes in
Server Administrator are displayed as read-only. You can edit the BIOS attributes 18 hours
after the operating system installation.
Workaround: To enable editing of the Server Administrator BIOS attributes, launch
Lifecycle Controller while booting.
• DF552204: On Mozilla Firefox browsers (versions 10, 11 and 12), Server Administrator fails
to launch if IPv6 address is used.
This is a known issue. For more information, see
https://bugzilla.mozilla.org/show_bug.cgi?id=633001.
• BITS04016: In case of Boot/HDD/UEFI sequence, if they are read-only, then toggle
buttons
(+ and -) and submit button are not visible. On BIOS setup page, dependencies
may exist
between the various attributes for Bios settings. Setting an attribute value
may change the
state of the dependent attributes to non-editable or editable. For
example, changing the
Boot Mode to UEFI from the Boot Settings page does not allow
you to configure the Boot
or Hard-Disk Drive Sequence in the BIOS Boot Settings page.
When the page is non-
editable, the toggle buttons on the page allows toggling the
order of the boot sequence.
However, settings cannot be configured since “Apply”
button will not available to submit
the settings.
• BITS050574: On 11G and 12G systems running the Linux OS, the omreport system
summary command displays “RAC Command Interface” as 7.1.0. “RAC Command
Interface”
is a DRAC4 RPM and its version is 7.1. It is installed as a dependent package for
iDRAC6 and
iDRAC7 Command Interface packages.
• If a new certificate imported to Server Administrator is not active after restarting the
Web server, restore the previous certificate.
To restore the previous certificate, do the following:
1. Stop the Web server.
2. Perform one of the following as