Users Guide

Required Command Levels (1, 2, 3) and
name=value pair
Optional name=value pairs Use
controller number and ENCLOSUREID is
the enclosure number. For example:
controller=0 enclosure=2
NOTE: This command is not
supported on Blackplane, SCSI,
and SWRAID controllers.
Omreport Battery Status
The following table describes the syntax for the omreport Battery commands:
Table 99. omreport Battery Commands
Required Command Levels (1, 2, 3) Optional name=value pairs Use
omreport storage battery Displays all batteries present on all
controllers on the system (Some
controllers do not have batteries).
controller=id, where id is the controller
number. For example: controller=0
Displays the battery on the specified
controller.
controller=id battery=id, where id is the
controller number. For example:
controller=0
Displays the specified battery.
Omreport Global Information
The following table describes the syntax for the omreport Global Information commands:
Table 100. Omreport Global Information Commands
Required Command Levels (1, 2, 3) Optional name=value pairs Use
omreport storage globalinfo
Displays whether smart thermal shutdown
is enabled or disabled. For more
information, see Omconfig Global Enable
Smart Thermal Shutdown.
Displays the hot spare protection policy
that you have set. For more information on
setting hot spare protection policy, see the
Dell OpenManage Server Administrator
Storage Management User’s Guide at
dell.com/support/manuals.
Omreport Connector Status
The following table describes the syntax for the omreport Connector commands:
Table 101. omreport Connector Commands
Required Command Levels (1, 2, 3) Optional name=value pairs Use
omreport storage connector
Displays all connectors present on all controllers
on the system.
133