Users Guide

Required Command Levels (1, 2, 3) Optional name=value pairs Use
NOTE: This command works only when
the controller ID is specified.
controller=id, where id is the
controller number. For example:
controller=0
Displays the connectors on the specified
controller.
controller=id connector=id, where id
is the connector number. For
example, connector=0
Displays the specified connector.
NOTE: When the connectors are
connected to the enclosure in redundant
path mode, the Name of the connector is
displayed as Logical Connector.
Omreport Cachecade Status
The following table describes the syntax for the omreport Cachecade commands
Table 102. omreport Cachecade Commands
Required Command Levels (1, 2,
3)
Optional name=value pairs Use
omreport storage cachecade Displays property information for all
cachecades on all controllers.
controller=id, where id is the controller
number. For example, controller=0.
Displays all cachecades on the specified
controller.
controller=id cachecade=id, where id is the
controller number and the cachecade number.
For example, controller=0 cachecade=1.
Displays the specified cachecade on the
controller.
Omreport PCIe SSD Status
The following table describes the syntax for the omreport pciessd commands.
Table 103. omreport PCIe SSD Command
Required Command Levels (1, 2, 3) And
name=value pair
Optional name=value pairs Use
omreport storage pciessd
Displays the properties of the PCIe SSD
subsystem.
subsystem=id Displays the properties of the specified
PCIe subsystem.
Omreport Storage Tape
The following table describes the syntax for the omreport storage tape command.
134