Users Guide

Table 104. Omreport Storage Tape Commands
Required Command Levels (1, 2,
3)
Optional name=value pairs Use
omreport storage tape Display tape drive properties.
controller=id, where id is the controller
number. For example: controller=0.
Displays all tape drives.
connector=id Displays all the tape drives on the specified
connector.
tape=<tape id>, where
tapeid=id=<connector:targetID>
Displays the specified tape drive.
Omreport NVMe adapter
The following table describes the syntax for the omreport nvmeadapter commands.
Table 105. omreport NVMe adapter command
Required Command Levels (1, 2, 3) And
name=value pair
Optional name=value pairs Use
omreport storage nvmeadapter
Displays the properties of the NVMe
adapters.
controller=id, where id is the controller
number. For example, controller=0.
Displays the properties of all the NVMe
adapters on the specified controller.
controller=id, nvmeid=id, where id is the
controller number and the NVMe adapter
respectively. For example, controller=0
nvmeid=1.
Displays the properties of the specified
NVMe adapter on the specified controller.
135