Users Guide

name=value pair 1 attribute= name=value pair 2 setting= Description
system. To view the set alias names, run
the command omreport chassis
biossetup attribute=bootorder
NOTE: On Linux systems, user or
user groups upgraded to
administrator or administrator
groups cannot configure this BIOS
setup setting.
attribute=cstates setting=enabled | disabled
• enabled: Enables the processor to go
into a deep sleep state when the
system is not utilized.
• disabled: Disables the processor to go
into a deep sleep state when the
system is not utilized.
attribute=conredirect setting=enabled | disabled
• enabled: Redirects the BIOS screen
output over serial port 1. Keyboard and
text output are redirected over serial
port 2.
• disabled: Turns off the BIOS console
redirection.
attribute=cpucle setting=enabled | disabled
• enabled: Enables processor C1-E after
system reboot.
• disabled: Disables processor C1-E
after system reboot.
attribute=cpuht setting=enabled | disabled
• enabled: Enables logical processor
hyperthreading.
• disabled: Disables logical processor
hyperthreading.
attribute=cpuvt setting=enabled | disabled
• enabled: Enables virtualization.
• disabled: Disables virtualization.
attribute=cpuxdsupport setting=enabled | disabled
• enabled: Enables Execute Disable
(XD) support on the system.
• disabled: Disables XD support on
system.
attribute=cpucore setting=1 | 2 | 4 | 6 | 8 | 10 | 12 |all
• 1: Enables one core per processor.
• 2: Enables two cores per processor.
• 4: Enables four cores per processor.
• 6: Enables six cores per processor.
• 8: Enables eight cores per processor.
• 10: Enables ten cores per processor.
• 12: Enables twelve cores per
processor.
• all: Enables the maximum cores per
processor.
attribute=dbs setting=enable | disable
• enable: Enables Demand Based
Switching (DBS) on the system.
• disable: Disables DBS on the system.
59