Users Guide
Property Denition
it is unable to display the slot ID and Embedded for embedded
controllers.
NOTE: If Slot Not Available is displayed, you can identify
the slot ID by selecting the System > Main > System
Chassis > Slots object in the tree view and selecting the
Information tab. The Slot ID property on this tab may
display the correct information.
State Displays the state of the controller. Possible values are:
• Ready — The controller is functioning normally.
• Degraded — The controller has suered a failure of a
component and is operating in a degraded state.
• Failed — The controller has suered a failure of one or more
components and is no longer functioning.
Firmware Version Displays the version of the rmware available on the controller.
Minimum Required Firmware Version Displays the minimum rmware version that is required by Storage
Management. This property is displayed only if the controller
rmware does not meet the minimum requirement.
Driver Version Displays the version of the drivers installed on the controller.
Minimum Required Driver Version Displays the minimum driver version that is required by Storage
Management. This property is displayed only if the controller driver
does not meet the minimum requirement.
Number of Connector Displays the number of connectors available on the controller. Each
connector can be attached to physical disks or an enclosure.
Depending on the controller type, the connector can be either a
SCSI channel or a SAS port.
Rebuild Rate The rebuild rate is the percentage of the resources available on the
system dedicated to rebuild a failed disk when a rebuild is
necessary. For more information on rebuild rate, see Setting The
Rebuild Rate.
Alarm State Displays whether the alarm on the controller is enabled or disabled.
Cluster Mode Indicates whether the controller is part of a cluster conguration.
Storage Components
For information on attached controllers, see Controllers.
48
Storage Information And Global Tasks