CLI Guide

autoreplacememberonpredictivefailure= <enabled
| disabled> persistenthotspare=<enabled |
disabled> nrdiskcachepolicy=<enabled | disabled
|unchanged>
Example to
Example
Enable revertible hot spare and replace member operation.
omconfig storage controller action=
setchangecontrollerproperties
allowrevertiblehotspare
andreplacemember=enabled controller=1
Example to
Example
Allows to enable, disable, or not to change the Non-RAID Hard Disk
Drives. This is applicable only to Disk Cache Policy.
omconfig storage controller action=
setchangecontrollerproperties controller=1
nrdiskcachepolicy=enabled
Omcong Discard Preserved Cache
Table 173. Omcong Discard Preserved Cache
Description Discards the preserved cache on the controller.
NOTE: To check if the controller has a preserved cache, type omreport storage controller
controller=id. If the system displays Preserved Cache=yes, it indicates the presence of the
preserved cache.
Syntax
omconfig storage controller action= discardpreservedcache controller=id
force=enabled | disabled
If you set force=enabled, the cache is discarded irrespective of whether the controller detects a foreign or an oine
virtual disk.
Example to Discard the preserved cache.
Example
omconfig storage controller action= discardpreservedcache controller=1 force=enabled
CAUTION: Discarding the preserved cache can result in data loss. It is recommended that you run this
command using the force=disabled option.
NOTE: If a foreign conguration is detected, then the preceding command using force=disabled option
fails. To avoid data loss, import the foreign conguration and ush the preserved cache to disk. To discard
preserved cache forcefully, either clear the foreign conguration and run the proceeding command, or run
the proceeding command using force=enabled option.
178 Omcong storage commands