CLI Guide

name=value pair 1 attribute= name=value pair 2 setting= Description
• alternate: Maps to Serial
device1=COM2, Serial device2=COM1
• com1: Sets serial port address to COM1.
• com2: Sets serial port address to COM2.
attribute=serialcom setting=o | on | com1 | com2 |
onwithconsole
• o: Disables serial communication
setting.
• on: Enables serial communication setting
without console redirection.
• com1: Enables serial communication
setting with console redirection through
COM1.
• com2: Enables serial communication
setting with console redirection through
COM2.
• onwithconsole: Enables serial
communication with console redirection
through COM1 and COM2.
NOTE: The setting onwithconsole is
supported only on Dell blade
systems.
attribute=serialport1 setting=o | auto | com1 | com3 | bmcserial
| bmcnic | rac | com1bmc
• o: Disables serial port 1.
• auto: Maps serial port 1 to a COM port.
• com1: Maps serial port 1 to COM port 1.
• com3: Maps serial port 1 to COM port 3.
• bmcserial: Maps serial port 1 to BMC
Serial.
• bmcnic: Maps serial port 1 to the
Baseboard Management Controller
(BMC) NIC.
• rac: Maps serial port 1 to the Remote
Access Controller (RAC.)
• com1bmc: Maps serial port 1 to COM
port 1 bmc.
NOTE: This command is applicable
only on selected x8xx systems.
attribute=serialport2 setting=o | auto | com2 | com4
• o: Disables serial port 2.
• auto: Maps serial port 2 to a COM port.
• com2: Maps serial port 2 to COM port 2.
• com4: Maps serial port 2 to COM port 4.
attribute=speaker setting=on | o
• on: Enables the speaker.
• o: Disables the speaker.
attribute=cputurbomode setting=enabled | disabled
CPU turbo mode can increase the CPU
frequency when the system is operating
below the thermal, power, or current limits.
• enabled: Enables CPU Turbo Mode.
• disabled: Disables CPU Turbo Mode.
70 Omcong Managing Components Using The Instrumentation Service