Users Guide

Properties Description
Read Only — The drive is in read-only mode. Users must save open
les, if any, to another device and replace or remove the device. If
this scenario occurs within three years of the device installation,
this failure is covered under warranty. The drive is in read-only
mode if the value for percent lifetime used is less than 100 percent
and that for write protect progress is equal to 90 percent.
Driver Version Displays the version of the driver that is installed on the PCIe SSD
sub-system.
NOTE: Storage Management displays Not Applicable for
subsystem for which the driver version cannot be
obtained.
Remaining Rated Write Endurance
Displays information on the SSD renewal/replacement based on the
amount of write workloads. This eld indicates the total remaining
programs or erase-cycles available on the SSD, based on the
cumulative specication of the total NAND (Negated AND or NOT
AND) Flash chips in the SSD.
NOTE: This option is applicable to Micron PCIe SSDs,
Non-Volatile Memory Express (NVMe) PCIe SSDs, and
SAS/SATA SSDs.
Firmware Revision Displays the rmware version of the physical device.
NOTE: The updated rmware version reects on the
Storage Management page after a service restart for the
NVMe drives which supports rmware update without
reset.
Model Number Displays the Piece Part Identication (PPID) of the PCIe SSD.
Capacity Displays the capacity of the device.
Vendor ID Displays the hardware vendor of the device.
Product ID Displays the product ID of the device.
Serial No. Displays the serial number of the device.
PCIe Negotiated Link Speed Displays the current negotiated transfer speed of the physical
device in GT/s.
PCIe Maximum Link Speed Displays the capable transfer speed of the physical device in GT/s.
PCIe Negotiated Link Width Displays the current negotiated link width of the physical device.
PCIe Maximum Link Width Displays the capable link width of the physical device.
Form Factor Displays the form factor of the device. Possible values are:
Add-in Card — For HHHL devices
2.5 inches — For physical devices other than a HHHL device.
Sub Vendor Displays the vendor name of the device.
Available Spare Displays the available spare value set for all PCIe SSDs / HHHL.
The new disk will have 100% spare which comes down as per the
usage.
34 PCI Express Solid-State Device Support