Users Guide

54 Setup and Administration
To enable SNMP Set operations on the system running Server Administrator,
edit the /etc/snmp/snmpd.conf SNMP agent configuration file and perform
the following steps:
1
Find the line that reads:
access publicgroup "" any noauth exact all none
none
or
access notConfigGroup "" any noauth exact all none
none
2
Edit this line, replacing the first none with all . When edited, the new
line should read:
access publicgroup "" any noauth exact all all
none
or
access notConfigGroup "" any noauth exact all all
none
3
To enable SNMP configuration changes, restart the SNMP agent by typing:
service snmpd restart
Configuring Your System to Send Traps to a Management Station
Server Administrator generates SNMP traps in response to changes in the
status of sensors and other monitored parameters. One or more trap
destinations must be configured on the system running Server Administrator
for SNMP traps to be sent to a management station.
To configure your system running Server Administrator to send traps to
a management station, edit the /etc/snmp/snmpd.conf SNMP agent
configuration file and perform the following steps:
1
Add the following line to the file:
trapsink IP_address community_name
where IP_address is the IP address of the management station and
community_name is the SNMP community name
2 To enable SNMP configuration changes, restart the SNMP agent by
typing:
service snmpd restart