Users Guide

Installing Management Station Software 87
NOTE: You have to type the ADDLOCAL, REINSTALL, and REMOVE CLI parameters
in upper case as they are case-sensitive.
You can include the ADDLOCAL customization parameter on the command
line, and assign the feature ID (or IDs) of the software feature that you would
like to install. An example is:
msiexec.exe /i MgmtSt.msi ADDLOCAL=RACMS /qb
This command runs the installation for management station and installs only
Remote Access Controller management station, in an unattended and
verbose (with messages) mode.
You can include the REINSTALL customization parameter on the command
line, and assign the feature ID (or IDs) of the software feature that you would
like to reinstall. An example is
msiexec.exe /i MgmtSt.msi REINSTALL=RACMS /qb
This command runs the installation for only the management station and
reinstalls Remote Access Controller management station, in an unattended
and verbose mode.
The REMOVE customization parameter can be included on the command
line and assigned the feature ID (or IDs) of the software feature that you
would like to uninstall. An example is
msiexec.exe /i MgmtSt.msi REMOVE=RACMS /qb
This command runs only the installation for management station and
uninstalls Remote Access Controller management station, in an unattended
and verbose mode.
Table 6-2. Feature IDs for the Management Station
Feature ID Description
ADS Active Directory Snap-in Utility
BMU Baseboard Management Controller Management Utility
ITA IT Assistant
RACMS DRAC Tools