Reference Guide

ENC13
Message Unsupported configuration detected on
arg1 . arg2 arg3
Arguments
–
arg1 =
Enclosure Name
–
arg2 =
EMM0 1
–
arg3 =
EMM1 2
Detailed Description An unsupported configuration was detected. The SCSI rate of the Enclosure
Management Modules (EMMs) are not the same.
Recommended Response Action Replace one of the EMMs with the matching SCSI rate EMM.
Category Storage
SubCategory ENC = Storage Enclosr
Severity Severity 2 (Warning)
LCD Message No LCD message display defined.
Initial Default. None
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE
ENC14
Message The number of enclosures connected on
arg1 has exceeded the maximum limit
supported by the controller.
Arguments
–
arg1 =
controller name
Detailed Description There are too many enclosures attached to the controller port. When the enclosure
limit is exceeded, the controller loses contact with all enclosures attached to the port.
This is an unsupported configuration.
Recommended Response
Action
Remove the extra enclosures. Refer to the storage hardware documentation for
maximum number of enclosures that can be connected.
Category Storage
SubCategory ENC = Storage Enclosr
Severity Severity 1 (Critical)
Trap/EventID 4337
LCD Message No LCD message display defined.
Initial Default. SNMP Alert
253