Reference Guide

JCP008
Message Job completed with errors.
Detailed Description Multiple attributes were set in the operation but some set attribute actions were not
successful. For example, setting an attribute that is not valid for the component being
configured,
Recommended Response
Action
Examine the results of the configuration job in the Lifecycle Log for the source of the
errors. Modify the settings as necessary and resubmit the job.
Category Configuration
SubCategory JCP = Job Control
Severity Severity 2 (Warning)
LCD Message No LCD message display defined.
Initial Default. None
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
FALSE FALSE FALSE FALSE TRUE FALSE FALSE FALSE FALSE
JCP009
Message Scheduled job was cancelled.
Detailed Description Scheduled jobs were deleted as a result of a cancel job request. The job cancellation
request is manually or programmatically initiated. Lifecycle Controller enters Recovery
mode when unrecoverable and persistent errors occur.
Recommended Response
Action
If the job was not cancelled manually, then Lifecycle Controller may be in Recovery
mode. To verify or change Recovery mode, use F2 Setup to select iDRAC Configuration
then Lifecycle Controller Settings.
Category Configuration
SubCategory JCP = Job Control
Severity Severity 3 (Informational)
LCD Message No LCD message display defined.
Initial Default. None
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE
JCP010
Message The command was successful.
324