Reference Guide

SubCategory JCP = Job Control
Severity Severity 1 (Critical)
LCD Message No LCD message display defined.
Initial Default. None
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE
JCP013
Message Missing parameter(s)
arg1
Arguments
–
arg1 =
parameters
Detailed Description One or more required input parameters needed for the operation are missing.
Recommended Response Action Refer to the documentation for the operation being attempted and provide valid
values for the identified parameters.
Category Configuration
SubCategory JCP = Job Control
Severity Severity 2 (Warning)
LCD Message No LCD message display defined.
Initial Default. None
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE
JCP014
Message Maximum jobs per queue exceeded.
Detailed Description The number of jobs specified in the SetupJobQueue request combined with the existing job
count contains more jobs IDs than the maximum number of jobs supported by the system
(256). Completed jobs are automatically deleted if they are older than the delete on
completion timeout setting.
Recommended
Response Action
Reduce the number of jobs specified in the operation or reduce the existing job count before
retrying the operation. Perform one of the following to reduce the job count: 1) Delete one or
more jobs and retry the operation. 2) Wait until existing jobs have an elapsed time since
completion that is greater than the delete on completion timeout setting and are
automatically deleted. 3) Change the delete on completion timeout setting to a smaller value
so that completed jobs are automatically deleted sooner.
Category Configuration
326