Reference Guide

SubCategory JCP = Job Control
Severity Severity 2 (Warning)
LCD Message No LCD message display defined.
Initial Default. None
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE
JCP024
Message Lifecycle Controller is in use. This job starts when Lifecycle Controller is available.
Detailed Description Lifecycle Controller cannot gain access to internal storage due to use by another
application or operation. This job starts when Lifecycle Controller is available.
Recommended Response
Action
Wait for current Lifecycle Controller operation to complete. Verify that the system is: 1)
Not currently in Lifecycle Controller Unified Server Configurator 2) Not waiting for user
intervention at F1/F2 POST error 3) Not in any of the device or controller Option ROMs.
Category Configuration
SubCategory JCP = Job Control
Severity Severity 3 (Informational)
LCD Message No LCD message display defined.
Initial Default. None
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE
JCP025
Message Lifecycle Controller is not enabled.
Detailed Description Lifecycle Controller must be enabled to perform the requested operation. Lifecycle
Controller can be enabled in the F2 Setup application or through a remote operation.
Recommended Response
Action
If Lifecycle Controller is in Recovery mode a firmware update of Lifecycle Controller may
be required. To change the Lifecycle Controller mode, do the following: 1) Restart the
system and press F2 to launch the System Setup application 2) Select iDRAC
Configuration 3) Select Lifecycle Controller Settings to enable Lifecycle Controller.
Category Configuration
SubCategory JCP = Job Control
Severity Severity 3 (Informational)
LCD Message No LCD message display defined.
331