Reference Guide

Severity Severity 2 (Warning)
LCD Message No LCD message display defined.
Initial Default. LC Log
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
FALSE FALSE FALSE FALSE TRUE FALSE FALSE FALSE FALSE
PSU1
Message Power supply in
arg1 was disrupted.
Arguments
–
arg1 =
Enclosure name
Detailed Description The power supply unit is not receiving input power. The power cable may not be
connected properly or removed. This can happen if there is AC failure or problems with
the power strip attached to the enclosure power supply.
Recommended Response
Action
Reconnect the power cable to the power supply unit if it was disconnected. Restore the
input AC power supply. Make sure the power supply is restored to the enclosure from
the mains.
Category Storage
SubCategory PSU = Power Supply
Severity Severity 2 (Warning)
Trap/EventID 4234
LCD Message No LCD message display defined.
Initial Default. SNMP Alert
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
TRUE FALSE TRUE FALSE TRUE FALSE FALSE FALSE FALSE
PSU11
Message Power supply in
arg1 has failed.
Arguments
–
arg1 =
Enclosure name
Detailed Description The power supply unit has failed.
Recommended Response Action Check for other messages related to the state of the power supply/enclosure. These
may help determine the cause of this event. Contact technical support if the issue
still persists.
Category Storage
SubCategory PSU = Power Supply
545