USB Enhanced and Integrated Ethernet Service Manual

System Setup Program A-5

Power Management With the Power Management category

enabled, DPMS monitors and most EIDE

drives automatically switch into low-power

mode during periods of system inactivity.

CAUTION: Before enabling this feature,

check the monitor documentation to make

sure the system has a DPMS-compliant

monitor. Otherwise, there is a risk of dam-

aging the monitor.

NOTE: Not all EIDE hard-disk drives support

this feature. Enabling this feature for drives

that do not support it may cause the EIDE

drive to become inoperable until the system is

restarted and the Power Management category

is disabled.

Sound Enables (On [default]) or disables (Off) the

audio controller.

NIC Enables (On) or disables (Off) the network

interface controller.

Mouse Enables or disables the built-in PS/2-

compatible mouse port.

Serial Port 1

Serial Port 2

Configures system’s built-in serial ports.

Parallel Port Configures system’s built-in parallel port. The

port’s I/O address may be set to 278H, 3BCH,

or 378H.

Otherwise, the port may be dis-

abled.

Parallel Modes Controls whether system’s built-in parallel port

acts as an AT-compatible (unidirectional) or

PS/2-compatible (bidirectional) port.

IDE Hard Disk Enables system’s built-in EIDE hard-disk drive

interface.

Diskette Enables system’s built-in diskette controller.

USB Enables (On) or disables (Off

[default]) the

USB connectors.

NOTE: This category appears only on GXpro

systems containing the 10/100-Mbps Ethernet

NIC.

Speaker Enables on-board speaker.

Table A-1. System Setup Categories

(continued)