User's Manual

If the message is not listed, see the documentation for the operating system or the program that was running when the message appeared.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
Afilenamecannotcontainanyofthefollowingcharacters:\/:*?"<>| Do not use these characters in filenames.
Arequired.DLLfilewasnotfound The program that you are trying to open is missing an essential file. To remove and then reinstall the program:
1. Click the Start button, click Control Panel, and then click Add or Remove Programs.
2. Select the program you want to remove.
3. Click the Change or Remove Program icon.
4. See the program documentation for installation instructions.
Alert! Previous attempts at booting this system have failed at checkpoint [nnnn]. For help in resolving this problem, please note this checkpoint and
contactDellTechnicalSupport Contact Dell and report the checkpoint code (nnnn) to the support technician.
Attachmentfailedtorespond See "Drive Problems."
Badcommandorfilename Ensure that you spelled the command correctly, put spaces in the proper place, and used the correct pathname.
Bad error-correctioncode(ECC)ondiskread See "Drive Problems."
Controllerhasfailed See "Drive Problems."
Dataerror See "Drive Problems."
Decreasingavailablememory
See "Lockups and Software Problems."
Diskettedrive0seekfailure See "Drive Problems."
Diskettereadfailure
See "Drive Problems."
Diskettesubsystemresetfailed Run the Dell Diagnostics.
Diskettewriteprotected Slide the write-protect notch on the floppy disk to the open position.
Drivenotready Put a floppy disk in the drive.
GateA20failure
See "Lockups and Software Problems."
Hard-diskconfigurationerror
Hard-diskcontrollerfailure
Hard-diskdrivefailure
Hard-diskdrivefailure
See "Drive Problems."