User's Manual


Insertbootablemedia— Insert a bootable floppy disk or CD.

Invalid configuration information -pleaserunSETUPprogram— Enter system setup and correct the computer configuration information.

Keyboardfailure— See "Keyboard Problems."

Memory address line failure at address, read value expecting value — See "Lockups and Software Problems."

Memoryallocationerror—

1. Turn off the computer, wait 30 seconds, and then restart the computer.
2. Try to run the program again.
3. If the error message appears again, see the software documentation for additional troubleshooting suggestions.

Memory data line failure at address, read value expecting value — 

Memory double word logic failure at address, read value expecting value — 

Memory odd/even logic failure at address, read value expecting value— 
Memory write/read failure at address, read value expecting value — 

MemorysizeinCMOSinvalid— 
See "Lockups and Software Problems."

Nobootdeviceavailable— 
l If the floppy drive is your boot device, ensure that a bootable floppy disk is in the drive.
l If the hard drive is your boot device, ensure that the cables are connected and that the drive is installed properly and partitioned as a boot device.
l Enter system setup and ensure that the boot sequence information is correct.

No boot sector on hard-diskdrive— Enter system setup and ensure that the computer configuration information for the hard drive is correct.

Notimertickinterrupt— Run the Dell Diagnostics.

Non-systemdiskordiskerror— Replace the floppy disk with one that has a bootable operating system or remove the floppy disk from drive A and restart
the computer.

Notabootdiskette— Insert a bootable floppy disk and restart your computer.

Notenoughmemoryorresources.Closesomeprogramsandtryagain— Close all windows and open the program that you want to use. In some cases,
you might have to restart your computer to restore computer resources. If so, run the program that you want to use first.

Operatingsystemnotfound— Contact Dell.

PlugandPlayConfigurationError—

1. Turn your computer off, unplug it from the electrical outlet, and then remove all but one of the cards.
2. Plug in your computer and reboot it.
3. If the message reappears, the installed card might be malfunctioning. If the message does not reappear, turn off the computer and reinsert one of
the other cards.
4. Repeat this process until you identify which card is malfunctioning.
