Owners Manual

Installing the intrusion switch

1 Insert the intrusion switch into the slot on the computer.

2 Route the intrusion switch cable through the fan grommet.

3 Connect the intrusion switch cable to the connector on the system board.

4 Close the front bezel door.

5 Install the:

• bezel

• cover

6 Follow the procedure in After Working Inside Your Computer.

Removing the power switch

1 Follow the procedure in Before Working Inside Your Computer.

2 Remove the:

• cover

• bezel

3 Open the front bezel door.

4 To remove the power switch:

a Disconnect the power switch cable from the system board [1].

b Unroute the power switch cable from the retention clip.

c Press the release tab [2] and slide the power switch out of the computer [3].

Removing and installing components