Owners Manual
b Unroute the intrusion switch cable from the fan grommet [2].
c Remove the adhesive tape that holds the intrusion switch cable on the system fan [3].
d Slide the intrusion switch and push it to remove from the computer [4].
Installing intrusion switch
1 Insert the intrusion switch into the slot on the computer.
2 Ax the adhesive tape that holds the intrusion switch cable on the system fan.
3 Route the intrusion switch cable through the fan grommet.
4 Connect the intrusion switch cable to the connector on the system board.
5 Close the front panel door.
6 Install the:
a bezel
b cover
7 Follow the procedure in After working inside your computer.
40
Disassembly and reassembly