Owners Manual

FInstalling SD card reader

1 Insert the SD card reader into the slot on the system board.

2 Replace the screw(6+/-1) to secure the SD card reader to the front panel door.

NOTE: The screw holder is beneath the SD card reader.

Connect the SD card reader cable to the connector on the system board.

4 Close the front panel door.

5 Install the:

a Front bezel

b Back cover

6 Follow the procedure in After working inside your computer.

Memory modules

Removing memory module

1 Follow the procedure in Before working inside your computer.

2 Remove the:

a Back cover

b Front bezel

3 Open the Front panel door.

4 To remove the memory module:

a Pull the clips securing the memory module until the memory module pops up.

b Lift the memory module from the connector on the system board.

Installing memory module

1 Align the notch on the memory module with the tab on the connector.

2 Insert the memory module into the connector.

3 Press the memory module until the memory module retention tabs click into place.

4 Close the front panel door.

5 Install the:

a Front bezel

b Cover

6 Follow the procedure in After working inside your computer.

Disassembly and reassembly