Users Guide
니다.
Not a boot diskette— 부팅 플로피 디스크를 삽입하고 컴퓨터를 재시작합니다.
Not enough memory or resources. Close some programs and try again— 모든 창을 닫고 사용할 프로그램만 엽니다. 간혹 컴퓨터의 자원을 복구하
기 위해 컴퓨터를 재시작해야 하는 경우도 있습니다. 이런 경우 먼저 사용할 프로그램을 실행합니다.
Operating system not found— Dell사에 문의합니다(Dell사에 문의하기 참조).
Plug and Play Configuration Error—
1. 컴퓨터의 전원을 끄고 전원 콘센트에서 분리한 다음 카드 하나만 제외하고 다른 카드를 모두 분리합니다.
2. 컴퓨터를 전원 콘센트에 연결하고 재부팅합니다.
3. 메시지가 다시 나타나면 설치된 카드가 오작동 중일 수 있습니다. 메시지가 다시 나타나지 않으면 컴퓨터를 끄고 다른 카드 중 하나를 다시 삽입합니다.
4. 오작동 중의 카드가 식별될 때까지 이 프로세스를 반복합니다.
Read fault—
Requested sector not found—
Reset failed—
드라이브 문제를 참조하십시오.
Sector not found—
l Windows 오류 검사 유틸리티를 실행하여 플로피 디스크나 하드 드라이브의 파일 구조를 검사합니다. 지시사항은 Windows 도움말을 참조하십시오.
l 많은 섹터에 결함이 있으면 데이터를 백업(가능한 경우)하고 플로피 디스크나 하드 드라이브를 다시 포맷합니다.
Seek error— 드라이브 문제를 참조하십시오.
Shutdown failure— Dell Diagnostics를 실행합니다(Dell Diagnostics 참조).
Time-of-day clock stopped—
Time-of-day not set-please run the System Setup program—
시스템 설치 프로그램을 시작(시스템 설치 프로그램 시작 참조)하여 날짜 또는 시간을 수정합니다. 문제가 지속되면 전지를 교체합니다(전지 교체 참조).
Timer chip counter 2 failed— Dell Diagnostics를 실행합니다(Dell Diagnostics 참조).
Unexpected interrupt in protected mode— Dell Diagnostics를 실행합니다(Dell Diagnostics 참조).
WARNING: Dell's Disk Monitoring System has detected that drive [0/1] on the [primary/secondary] EIDE controller is operating
outside of normal specifications. It is advisable to immediately back up your data and replace your hard drive by calling your support
desk or Dell—
즉시 사용할 수 있는 교체 드라이브가 없고 드라이브가 유일한 부팅 드라이브가 아닌 경우 시스템 설치 프로그램을 시작(시스템 설치 프로그램 시작 참조)하여 해당
드라이브 설정을 None(없음)으로 변경합니다. 컴퓨터에서 드라이브를 분리합니다.
Write fault—
Write fault on selected drive—
드라이브 문제를 참조하십시오.
<drive letter>:₩ is not accessible. The device is not ready— 선택한 드라이브가 해당 매체를 읽을 수 없습니다. 매체 유형에 따라 플로피, CD, DVD
또는 ZIP 디스크를 드라이브에 삽입하고 다시 시도합니다.