Dell OptiPlex All-in-One Stand Installation Guide
Notes, cautions, and warnings NOTE: A NOTE indicates important information that helps you make better use of your product. CAUTION: A CAUTION indicates either potential damage to hardware or loss of data and tells you how to avoid the problem. WARNING: A WARNING indicates a potential for property damage, personal injury, or death. © 2018 Dell Inc. or its subsidiaries. All rights reserved. Dell, EMC, and other trademarks are trademarks of Dell Inc. or its subsidiaries.
Contents 1 Before you begin............................................................................................................................................ 4 Safety instructions............................................................................................................................................................. 4 Before working inside your computer........................................................................................................................
1 Before you begin Safety instructions Use the following safety guidelines to protect your computer from potential damage and to ensure your personal safety. Unless otherwise noted, each procedure included in this document assumes that the following conditions exist: • You have read the safety information that shipped with your computer. • A component can be replaced or, if purchased separately, installed by performing the removal procedure in reverse order.
Safety precautions The safety precautions chapter details the primary steps to be taken before performing any disassembly instructions. Observe the following safety precautions before you perform any installation or break/fix procedures involving disassembly or reassembly: • Turn off the system and all attached peripherals. • Disconnect the system and all attached peripherals from AC power. • Disconnect all network cables, telephone, and telecommunications lines from the system.
2 Basic stand for Dell OptiPlex 5260 and 7460 Allin-One Topics: • Installing the basic stand • Removing the basic stand • Basic stand tilt Installing the basic stand 1 Follow the procedure in Before working inside your computer. 2 Insert the stand base into the slot on the basic stand. 3 Tighten the captive screw to secure the stand base to the basic stand.
4 To install the basic stand onto the computer: a b 5 Align the tabs on the basic stand with the slots on the back cover [1]. Snap the basic stand into place on the back cover [2]. Follow the procedure in After working inside your computer. Removing the basic stand 1 Follow the procedure in Before working inside your computer. 2 To avoid damaging the display, place the system on a flat, soft, and clean surface.
c 4 Slide and lift the basic stand off the back cover [3]. Follow the procedure in After working inside your computer.
3 Height adjustable stand for Dell OptiPlex 5260, 7460, and 7760 All-in-One Topics: • Installing the height adjustable stand • Removing the height adjustable stand • Height adjustable stand transform Installing the height adjustable stand 1 Follow the procedure in Before working inside your computer. 2 Insert the stand base into the slot on the height adjustable stand. 3 Tighten the captive screw to secure the stand base to the height adjustable stand.
4 To install the height adjustable stand onto the computer: a b 5 Align the tabs on the height adjustable stand with the slots on the back cover [1]. Snap the height adjustable stand into place on the back cover [2]. Follow the procedure in After working inside your computer. Removing the height adjustable stand 1 Follow the procedure in Before working inside your computer. 2 To avoid damaging the display, place the system on a flat, soft, and clean surface.
b c 4 Hold the tab in the release position and lift the height adjustable stand upward [2]. Slide and lift the height adjustable stand off the back cover [3]. Follow the procedure in After working inside your computer.
Height adjustable stand transform 12 Height adjustable stand for Dell OptiPlex 5260, 7460, and 7760 All-in-One
4 Height adjustable stand with optical disk drive for Dell OptiPlex 5260 and 7460 All-in-One Topics: • Installing the height adjustable stand with optical disk drive • Removing height adjustable stand with optical disk drive • Height adjustable stand with optical drive transform Installing the height adjustable stand with optical disk drive 1 Follow the procedure in Before working inside your computer.
4 Follow the procedure in After working inside your computer. Removing height adjustable stand with optical disk drive 1 Follow the procedure in Before working inside your computer. 2 To avoid damaging the display, place the system on a flat, soft, and clean surface. 3 Disconnect the optical drive cable from the USB slot on the back cover.
4 To remove the height adjustable stand: a b c Slide the release tab forward to release the height adjustable stand from the back cover [1]. Hold the tab in the release position and lift the height adjustable stand upward [2]. Slide and lift the height adjustable stand off the back cover [3].
Height adjustable stand with optical drive transform 16 Height adjustable stand with optical disk drive for Dell OptiPlex 5260 and 7460 All-in-One
5 Articulating stand for Dell OptiPlex 5260,7460, and 7760 All-in-One Topics: • Installing the articulating stand • Removing the Articulating Stand • Articulating stand tilt transform Installing the articulating stand 1 Follow the procedure in Before working inside your computer. 2 To install the articulating stand: a b 3 Align the tabs on the articulating stand with the slots on the back cover [1]. Snap the articulating stand into place on the back cover [2].
3 To remove the articulating stand: a b c 4 Slide the release tab forward to release the articulating stand from the back cover [1]. Hold the tab in the release position and lift the articulating stand upward [2]. Slide and lift the articulating stand off the back cover [3]. Follow the procedure in After working inside your computer.
6 Getting help Contacting Dell NOTE: If you do not have an active Internet connection, you can find contact information on your purchase invoice, packing slip, bill, or Dell product catalog. Dell provides several online and telephone-based support and service options. Availability varies by country and product, and some services may not be available in your area. To contact Dell for sales, technical support, or customer service issues: 1 Go to Dell.com/support. 2 Select your support category.